Site Information

 Loading... Please wait...
  • Image 1

Xcessive JZX90 1JZ Motor Mount Brackets - Kouki

4 Star Rating

Buy in bulk and save


Xcessive Manufacturing's new steel mount brackets for 1J and 2J blocks are designed after the JZX90 style with a slot for the motor mount point that allows movement of the engine forward or backward around an inch. While we call them JZX90 mounts, the slotted adjustment also covers the JZX81 placement and anywhere in between allowing you to place the transmission and shifter where you need. CNC cut from 1/4" steel plate, formed and plated, these engine brackets will handle all the punishment you can throw at them and last a life time doing it. If your doing 1J or 2J swap into a Cressida or just need a set of JZX90 mounts, these will do the job. Sold in pairs with all the bolts for both sides, (1st picture).

Motor mounts will require the index pin to be ground off to allow these brackets to properly sit flat due to the application of the slotted mount.

These mounts are designed for the cross member typical to the Kouki '91-'92 Cressida and do not match the angle found on the '89-'90 Zenki style Cressida and will cause premature failure of the motor mounts if used for the wrong application.


  1. Well designed. Perfect fit

    Posted by Carl on

    Very well designed. Fits perfectly. The ability to adjust the engine position is great. The only
    area that required improvement in my mind were the welds should be complete. I don't think they will be structurally less strong i would just prefer a complete weld for esthetics.

Write Review