Xcessive Manufacturing's new steel corrected geometry mount brackets for 1J and 2J blocks are designed after the JZX90 style with specific angles for the '89-'90 Zenki(Cressida) front cross member and a slotted upper hole for the motor mount point that allows movement of the engine forward or backward around an inch. While we call them JZX90 mounts, the slotted adjustment also covers the JZX81 placement and anywhere in between allowing you to place the transmission and shifter where you need. CNC cut from 1/4" steel plate, formed and plated, these engine brackets will handle all the punishment you can throw at them and last a life time doing it. If your doing 1J or 2J swap into a Cressida or just need a set of JZX90 mounts, these will do the job. Sold in pairs with all the bolts for both sides, (1st picture)
Motor mounts will require the index pin to be ground off to allow these brackets to properly sit flat due to the application of the slotted mount.
These mounts are designed for the cross member typical to the Zenki '89-'90 Cressida and do not match the angle found on the '91-'92 Kouki style Cressida and will cause premature failure of the motor mounts if used for the wrong application.