FlexLight LED strip is a direct replacement for any 194 size halogen bulb, or any festoon application. A number of adapters are included with the board so that you can choose the festoon size or 194 base size.
By changing the factory bulb to an LED, you can illuminate the area with a much brighter light, and add a pure white, luxury look.
The installation is 100% plug-and-play, just replace your factory bulb.
The Diode Dynamics FlexLight is an LED strip with mounting accessories and plug-and-play adapter, intended to replace your factory trunk light. Since the strip is flexible and durable, it can be installed in any way you prefer, using the mounting type of your choice.
Package includes an SMD strip with 30 SMDs, and these accessories:
- Velcro strip
- Adhesive pads
- Interchangeable wedge and festoon adapters, to fit any trunk light
For carpeted trunks, we recommend Velcro mounting. And for any other trunk, we recommend adhesive mounting, which uses strong 3M outdoor mounting tape.
Included in your order is ONE FlexLight.
These LEDs are available in crisp, bright colors including Cool White, Warm White, Blue, Red, Amber, and Green.
We strongly recommend cool white or warm white for the best visibility.
Lumens: BUYER BEWARE! Most sellers just provide "calculated" lumen numbers, based on the maximum potential brightness of the LED chips on the bulb. For example, if a bulb has five 10-lumen chips, they will rate it at 50 lumens. However, this is not accurate, as the design of an LED bulb does not get rid of heat fast enough to run the LEDs at maximum.
These "calculated" lumen ratings are much, much higher than the true, measured light output, so it will look like competitors' bulbs are brighter than ours. This is because Diode Dynamics does not provide inflated "calculated" numbers; we believe it is misleading. We test the actual brightness of the bulbs in our lab, to provide real lumen output measurements. Our measurements are accurate, but they are usually much lower than the misleading "calculated" figures.
LED Components. Diode Dynamics uses only the highest quality LED chips in the production of its bulbs. This means we use only brand-name suppliers such as Epistar, Cree, Osram, and Samsung.
While our bulbs may look the same as others on the market, most copycat bulbs use economy-grade LED chips in order to reduce costs. This greatly reduces the reliability and overall brightness of the bulb when you compare it to Diode Dynamics.
Construction. Although LED technology allows for extremely long bulb life, the market is flooded with cheap LED bulbs that fail prematurely due to inferior construction. The worst enemy of LEDs is excessive heat, and when bulbs are not designed properly, they do not disperse heat as well, leading to premature failure.
Off-brand, cheap bulbs exhibit poor solder uniformity, high levels of flux in the solder, uneven chip placement, low-gauge terminal wires, poor assembly, and bulbs held together with inferior adhesives. At best, solder joints will crack and fail on low-quality LEDs after a few weeks of use. In the worst case, these bulbs can damage housings as the extra flux and adhesive evaporates and creates a residue on the lens of the housing.
Diode Dynamics bulbs are produced with modern, computerized equipment, and only the best materials, to ensure complete uniformity, high quality, and long bulb life.